This could ruin the tire.With the 36-inch grinding disk, rough up the surface of the tire. Soak the tires in the solution for 10 minutes and remove. Apply mixture to tires using rag or a paint roller. It is best to do this two to three days before a race. If bleach and WD40 work its priety cheap to soften the tires
Always store Hoosier Racing Tires indoors at temperatures above 32° F. In this article we provide some practical ways to soften tires.One way to soften tires is to use kerosene.
Given this, it is not uncommon for people to make a homemade solution. Let the mixture dry on the tire and then add a second coat. Mix together a solution composed of 1/3 acetone, 1/3 mineral spirits and 1/3 transmission fluid. Hoosier Tires, especially asphalt and hard compound tires, may experience Rubber Cracking if the tires are transported, crushed, flexed or stressed when frozen.
(I say its the heat, They say its the WD40 giving up) and ive seen modified drivers use bleach on the tires. Apply to the tires two days before the race.Take a gallon of WD40 and soak the tires directly in this. Be sure to create mixture in a well-ventilated area.Apply mixture to tires using rag or a paint roller.Allow tires to soak in mixture 15 to 30 minutes before racing.Consider using masks and gloves to ensure the least amount of contact with the tire softener solution.The use of tire softeners is banned at some racing forums.Ingredients used in tire softeners can be dangerous and should always be used with caution.Constance Courduff has been writing professionally since 2008 and enjoys publishing how-to articles for eHow. We use only Hoosier Racing Tires and there are numerous compounds, sizes and tire rules across the country. Deeper than 1/2 the depth may cause individual tread blocks to rip or “chunk” out. Mix the toluene, acetone and mineral spirits together. This will allow the solution to seep in. Fortunately, making tire softener is an extremely simple process.Mix together a solution composed of 1/3 acetone, 1/3 mineral spirits and 1/3 transmission fluid. When setting the depth of the blades for siping, place the siping head on the tread block and visually adjust the depth to 1/2 the thickness of the block. Allow tires to soak in mixture 15 to 30 minutes before racing.
They don't soften tires any more than a tire would soften by itself when it gets hot during the race. There are several products on the market but they can be expensive. To submit your questions or ideas, or to simply learn more about It Still Works, Many of these chemicals are toxic and can be dangerous if not handled properly. In go-carts they spray WD40 on them to soften them up. One way to soften tires is to use kerosene. This can be done the day the tires are needed. Step 3.
Mix one part paint thinner and one part diesel fuel together. they say they can feel the tires grip for around 5 laps and fall off. Using a paint roller, apply the mixture to the tire as if you were painting a wall. The depth should be set no deeper than 1/2 the depth of the tread blocks. I run the World of Outlaws (WoO) Craftsman Late Model Series most of the year, and we have a few different rules. Pre-mixed softeners are heftily priced per gallon, and many racers use a gallon a week. If you use this method it must be repeated each week or the rubber will get hard.Mix one part paint thinner and one part diesel fuel together. It is best to do this two to three days before a race. Warmers allow you to go all out from the start without having to heat up tires by making a few slow laps.
Always keep these chemical out of reach of children and follow the manufacturer's guidelines for disposal. 1.
This can be done at the track and brings about the quickest results.This article was written by the It Still Works team, copy edited and fact checked through a multi-point auditing system, in efforts to ensure our readers only receive the best information. Wear gloves and work in a well-ventilated area. How to Soften Tires Step 1. This will soften the rubber to create the effect you need. The use of tire softeners has been controversial in many racing arenas. Be sure to create mixture in a well-ventilated area. Bleach softens tires well. Tires can be hard and dry, decreasing their ability to grip the road or track. Next take the rags soaked in kerosene and wrap them around the tires. When we go to the Northeast we use the Hoosier … I dunno if that works or not. This chemical mixture makes tires softer, allowing them to better grip the racetrack.
Soak the tires in water first. Probably by oxidizing some of the sulfur from cross-links. Wrap the tires in foil until before the race. Car racers at times look for ways to soften the tires to help them grip the track. The following guidelines are provided to avoid this problem. Step 2. Be careful not to oversoak the tire with this mixture. She holds over 12 years of professional experience in working with children and families and holds a Master of Human Service degree from Lincoln University.Copyright 2020 Leaf Group Ltd. / Leaf Group Media, All Rights Reserved. It will only soften them slightly but does help the tires retain the grip on the track.Mix equal parts xylene and toluene and mix together.