Seemed it was getting caught on some of the fridge internals above the tray. Please help! Hope that helps.Yes I did read the replies and none worked however we just fixed it reading to put your hand inside the ice bucket and turn the silver coil a little and keep trying as its not lining up with the back and it worked : ) I've tried all these things... having the same issue. Top ice maker bucket won't slide back in I removed the top ice maker bucket to remove som – Learn about Samsung - 31.6 Cu. You must log in or register to reply here. Thread starter joshbosh111; Start date Apr 10, 2018; J. joshbosh111 Member. I had this same problem. The ice is made and pushed out of ice maker, but does not fall into the bucket. I thank you for your reply, now I know what needs to happen! I've included pictures of the back of my bucket and the inside of the compartment. Ft. French Door Refrigerator with Thru-the-Door Ice and Water - Stainless steel with 3 Answers – Best Buy FIXED RF23HCEDBSR Ice bucket won't go back in. ee. I suspect it is the alignment, but how do i check/know that? My ice dispenser bucket will not go back, do i need to adjust anything? Maybe they have dropped a little bit. Maybe they have dropped a little bit. For a better experience, please enable JavaScript in your browser before proceeding. I have been trying..... is there any sketch for people who still can not fit it correctly?
I had this same problem. I'm not sure what piece you're referring to. I loosened the two screws that hold the plastic piece above the ice tray and inserted a shim to hold the piece down closer towards the bottom of the tray. The ice machine won't dispense ice, and the ice bucket cannot be removed. My ice dispenser bucket will not go back, do i need to adjust anything? Seemed it was getting caught on some of the fridge internals above the tray. Marcel, stood on a stool and was able to see what you were referring to. Because the bucket is not pushed in all the way I'm certain that the connection is not being made in the back where the plastic rotating piece in the refrigerator is supposed to mate with the metal "tongs" (don't know the exact terminology) that drive the metal spiral in the bucket to move the ice … what should it look out properly aligned?
I loosened the two screws that hold the plastic piece above the ice tray and inserted a shim to hold the piece down closer towards the bottom of the tray. I removed my ice bucket to clear a bunch of jammed ice out and now I can't get the ice bucket to go back in. Loosen the he screws and the tray went in easily, Thanks for the tip Removing the ice bucket from our Samsung French-door refrigerator gives new meaning to the term “ice bucket challenge.” After less than two years of ownership, our ice maker refused to dispense. I thank you for your reply, now I know what needs to happen! Maybe they have dropped a little bit. Hope that helps. I loosened the two screws that hold the plastic piece above the ice tray and inserted a shim to hold the piece down closer towards the bottom of the tray. My ice dispenser bucket will not go back, do i need to adjust anything? I'm sure I'm doing something really stupid here but I've tried for like any hour and can't figure it out. if I catch after the first cycle or two, I can just reach up and touch the cubes and they fall. I've submitted a support request, and even though there is a class action lawsuit for these ice makers, I'm being told it will be $200-300 + parts to fix a KNOWN issue. And if it still won't set back in place, you may need a new bucket because the release mechanism isn't working correctly and letting you set the bucket down on the door.